Are you feeling overwhelmed by the considered eradicating your overhead microwave? Don’t be concerned, it is not as daunting as it could appear. With a bit of preparation and the precise instruments, you’ll be able to simply take away your overhead microwave and release some much-needed house in your kitchen. On this complete information, we’ll stroll you thru each step of the method. Whether or not you are a seasoned DIYer or a kitchen novice, this information will empower you to sort out this job with confidence.
Earlier than you start, collect the required instruments and supplies. You will have a step ladder, a screwdriver, a pair of pliers, and probably a wire cutter. It is also a good suggestion to have a helper available to help you with lifting and stabilizing the microwave. Upon getting the whole lot you want, begin by disconnecting the ability to the microwave on the circuit breaker. Subsequent, take away the screws that safe the mounting bracket to the cupboard. As soon as the mounting bracket is unfastened, rigorously elevate the microwave out of the cupboard. Disconnect {the electrical} wires from the microwave and decrease it to the ground. Lastly, get rid of the microwave in line with native laws.
Eradicating an overhead microwave is usually a rewarding expertise, particularly in case you’re trying to improve or rearrange your kitchen. By following these steps, you’ll be able to safely and successfully take away your microwave with out damaging it or your kitchen. Nonetheless, it is vital to do not forget that in case you’re not comfy performing electrical work, it is best to seek the advice of a certified electrician. With a bit of effort and the precise strategy, you’ll be able to release precious house in your kitchen and benefit from the satisfaction of a job effectively achieved.
Eradicating the Higher Screws
Now that the microwave is supported, you’ll be able to start eradicating the higher screws. These screws are usually situated on the highest of the microwave, close to the again. They might be coated by a plastic panel, which you have to to take away first utilizing a screwdriver.
Upon getting situated the higher screws, use a screwdriver to take away them. Watch out to not drop the screws, as they are often tough to search out in the event that they fall into the microwave.
As soon as all the higher screws have been eliminated, you’ll be able to rigorously elevate the microwave off of the mounting bracket. Remember to maintain the microwave securely, as it may be heavy.
Ideas for Eradicating the Higher Screws
Listed below are some suggestions for eradicating the higher screws:
- Use a screwdriver that’s the right measurement for the screws. A screwdriver that’s too small will strip the screws, whereas a screwdriver that’s too giant will harm the microwave.
- Watch out to not overtighten the screws. Overtightening the screws can harm the microwave.
- In case you are having issue eradicating a screw, attempt utilizing a penetrating oil. Penetrating oil may help to loosen the screw in order that it may be eliminated extra simply.
Troubleshooting
In case you are having issue eradicating the higher screws, it’s attainable that they’re rusted or broken. On this case, you could want to make use of a drill to take away the screws. Listed below are some suggestions for utilizing a drill to take away screws:
- Use a drill bit that’s the similar measurement because the screws.
- Drill a pilot gap into the middle of the screw.
- Use a screwdriver to take away the screw.
Disconnecting the Wiring
Upon getting eliminated the duvet and accessed the wiring, proceed with the next steps to securely disconnect the microwave:
1. Flip off the Electrical energy
Find the circuit breaker or fuse field that controls the electrical energy to the microwave and change it off. This step is essential for security earlier than dealing with any electrical elements.
2. Take away the Screws
Utilizing a screwdriver, take away the screws that safe {the electrical} wires to the terminals on the microwave. Sometimes, these screws are situated on the again or backside of the unit.
3. Disconnect the Wires
Rigorously pull {the electrical} wires away from the terminals. To keep away from damaging the wires or terminals, use needle-nose pliers or insulated wire strippers to softly disconnect them.
4. Mark the Wires
To make sure correct reconnection later, mark or label the wires with tape or a marker. This step will make it easier to establish the corresponding wires when reattaching the microwave.
5. Wrap the Wires
For security and to stop quick circuits, wrap the uncovered wires with electrical tape. This may insulate the wires and scale back the chance of unintended contact throughout the removing and reinstallation course of. This is a desk summarizing the wire-wrapping course of:
| Objective | Steps |
|---|---|
| Insulating uncovered wires | Wrap every wire individually with electrical tape. |
| Securing the tape | As soon as wrapped, safe the tape by overlapping it a number of occasions. |
| Stopping quick circuits | Be certain that the tape totally covers the uncovered wires with none frayed or broken spots. |
Eradicating the Microwave from the Wall
1. Disconnecting the Energy
Unplug the microwave from the ability outlet. In case your microwave is hardwired, flip off the breaker or fuse that provides energy to the microwave.
2. Eradicating the Mounting Bracket
Find the mounting bracket that holds the microwave to the wall. Take away the screws that safe the bracket to the wall and to the microwave.
3. Lifting the Microwave from the Bracket
Grip the microwave firmly from either side and elevate it straight as much as take away it from the mounting bracket.
4. Eradicating the Screws from the Again of the Microwave
As soon as the microwave is free from the bracket, take away the screws from the again of the microwave that safe it to the wall. There needs to be two screws on the high and two on the backside.
5. Pulling the Microwave Ahead
Grip the microwave firmly and pull it straight towards you to take away it from the wall.
6. Eradicating the Energy Wire and Wiring
As soon as the microwave is obvious of the wall, take away the ability twine and another wiring that’s hooked up to it.
7. Eradicating the Help Brackets (if obligatory)
In case your microwave was put in with help brackets that stretch from the underside of the microwave to the ground, you have to to take away these brackets. There could also be screws or bolts that safe the brackets to the microwave and to the ground. Take away these fasteners and punctiliously elevate the microwave off of the brackets.
Patching the Gap
As soon as the microwave is eliminated, you may be left with a gap in your cupboard. There are a couple of alternative ways to patch this gap, relying on the scale and placement. For small holes, you’ll be able to merely fill them in with spackling paste or wooden filler. For bigger holes, you could want to chop a bit of plywood to suit the outlet after which connect it with screws or nails. As soon as the outlet is patched, you’ll be able to paint or stain it to match the remainder of the cupboard.
Listed below are the steps on patch a gap in your cupboard:
- Clear the world across the gap with a moist fabric.
- If the outlet is small, fill it in with spackling paste or wooden filler utilizing a putty knife.
- If the outlet is giant, reduce a bit of plywood to suit the outlet.
- Connect the plywood to the cupboard with screws or nails.
- Fill in any gaps across the plywood with spackling paste or wooden filler.
- Sand the patched space till it’s easy.
- Paint or stain the patched space to match the remainder of the cupboard.
| Materials | Instruments |
|---|---|
| Spackling paste or wooden filler | Putty knife |
| Plywood (if the outlet is giant) | Screws or nails |
| Sandpaper | Paint or stain |
Disconnecting Energy
1. Shut off the microwave’s circuit breaker or fuse at your house’s electrical panel.
2. Unplug the microwave from {the electrical} outlet.
Eradicating Gasoline Line
3. Shut off the fuel valve that provides the microwave.
4. Disconnect the fuel line from the microwave.
Eradicating Mounting Brackets
5. Find the mounting brackets that safe the microwave to the wall or cupboard.
6. Take away the screws or bolts that maintain the brackets in place.
Reducing the Microwave
7. Have a helper help the microwave as you rigorously take away it from the mounting brackets.
8. Carry the microwave down and place it on a sturdy floor.
Restoring Energy and Gasoline
Restoring Energy
9. Earlier than turning on the circuit breaker or fuse, rigorously examine all wires and connections.
10. If the whole lot appears safe, activate the circuit breaker or fuse and plug within the microwave.
Restoring Gasoline
11. Test for any leaks within the fuel line by making use of a soapy water resolution to all joints.
12. If no bubbles seem, activate the fuel valve and relight the microwave’s pilot mild.
| Sort of Circuit Safety | Location |
|---|---|
| Circuit Breaker | Electrical Panel |
| Fuse | Fuse Field |
How one can Take away an Overhead Microwave
Eradicating an overhead microwave is usually a daunting job, however it’s attainable to do it your self with the precise instruments and security precautions. Listed below are the steps on take away an overhead microwave:
- Flip off the ability to the microwave. This may be achieved on the circuit breaker or fuse field.
- Disconnect the microwave from {the electrical} outlet.
- Take away the mounting bolts. There are usually 4 bolts that maintain the microwave in place. Use a socket wrench to take away the bolts.
- Decrease the microwave barely. Have somebody make it easier to decrease the microwave slowly with the intention to disconnect the exhaust duct.
- Disconnect the exhaust duct. The exhaust duct is usually held in place by a clamp. Use a screwdriver to loosen the clamp and disconnect the duct.
- Take away the microwave. Rigorously elevate the microwave off of the mounting brackets and take away it from the kitchen.
Individuals Additionally Ask
How do I do know if my microwave is overhead?
Overhead microwaves are usually put in above the range or vary. They’re often mounted to the wall or ceiling.
What instruments do I must take away an overhead microwave?
You will have the next instruments to take away an overhead microwave:
- Socket wrench
- Screwdriver
- Step ladder
- Helper (non-obligatory)
Can I take away an overhead microwave myself?
Sure, it’s attainable to take away an overhead microwave your self with the precise instruments and security precautions. Nonetheless, you will need to observe that microwaves may be heavy and awkward to deal with. In case you are not comfy eradicating the microwave your self, it’s best to rent a certified equipment restore technician.
